FIRESEAL PARTY WALL BATTS 1200X168X100MMSKU: 1071417
Comes in pack of 5. Bradford Fireseal Party Wall Batt is designed for installation in Party Wall vertical joints applications only, maintaining 10% compression. Its purpose is to meet the requirements for fire resistance between adjacent tenancies, as set out in building codes and ordinances. Multiple layers must be stacked neatly and should be installed as one unit, however a single layer of Fireseal Party Wall Batt is prefered. Fireseal Party Wall Batts may be stacked to fill cavities up to 255mm in height. The Fireseal Party Wall Batts original height must be compressed by a min. of 10% and Bradford does not recommend more than 3 layers to be stacked without adequate support. When a batt is required to be extended in length, a Vee profile cut shall be made to both ends of each batt so to provide a butt joint. Any vertical joints in a stacked batt installation should be staggered. Batt lengths are to be cut so to provide a tight fit in the construction gaps opening width. They must be fitted tightly and accurately, following the profile of the gap.